Gutter Guard Company in Madison, WI
Madison has one of the best tree canopies of any city in the Midwest, and every bit of it ends up in your gutters. Oak tassels in May, maple helicopters in June, cottonwood fluff, pine needles and a solid wall of leaves every October. Add heavy Wisconsin snow and ice dams, and clogged gutters turn into wet basements, rotted fascia and icicles hanging off the eaves. We install gutter guards built for that load, from the Near East Side and Vilas to Middleton, Monona and Sun Prairie.
Typical cost: most Madison homes spend between $1,600 and $4,800 for professionally installed micro-mesh gutter guards. A small ranch with short runs costs less; a two-story home with steep roofs, many corners or new gutters costs more.
Install time: most homes are finished in one day, including cleaning, flushing and tightening the gutters before the guards go on.
How it works: a fine stainless steel mesh on a rigid aluminum frame lets rain through and keeps leaves, seeds and needles on top, where wind and sun clear them off.
Why Madison gutters clog: mature oaks and maples over almost every older neighborhood, spring seed drop, fall leaf piles and freeze-thaw winters that turn wet debris into ice.
Getting started: call or send the form. We measure every run, check the pitch, hangers, downspouts and fascia, and give you a written price.
If your gutters are sagging, leaking at the seams or pitched the wrong way, we will tell you before covering them. Guards work best on gutters that are sound.
Get a FREE Gutter Guard Quote
Most Madison homeowners call us after the same few headaches: climbing a ladder twice a year to scoop out leaves, water spilling over the front of the gutter during a summer storm, ice dams and icicles in February, or a downspout that clogs every time the maples drop their seeds.
Our gutter guard installation in Madison starts with the gutters themselves. We clean and flush every run, fix loose hangers and leaky seams, check that the gutters slope toward the downspouts, and then fit guards sized to your roof and your trees. The goal is simple: water goes into the gutter, debris stays out, and you stay off the ladder. Falls from ladders while cleaning gutters send plenty of homeowners to the emergency room every fall, and that is a risk nobody needs to keep taking.

Micro-mesh is our go-to guard for Madison homes. A surgical-grade stainless steel screen sits on a rigid aluminum frame and blocks everything down to shingle grit, while still taking in heavy rain.
It handles the small stuff that slips through cheaper screens, like maple seeds, oak tassels and pine needles, which is why it is the best fit under the big trees in neighborhoods like Vilas, Nakoma and Westmorland. Because the mesh is stainless, it will not rust in the gutter after years of wet leaves and road salt spray.

If your gutters are rusted, sagging or full of leaking seams, new seamless aluminum gutters are the better starting point. We form them on site to the exact length of each run, so the only joints are at the corners.
Pairing new seamless gutters with guards in a single visit means one setup, one cleanup and a system designed to work together.

Madison winters bring deep snow and long cold spells, and ice dams form when melting snow refreezes at the eaves. Clogged gutters make them worse because water has nowhere to go.
We install guards that shed snow better, plus heat cable in gutters and downspouts where ice dams keep coming back, so meltwater can drain instead of backing up under the shingles. Self-regulating cable only draws real power when it is cold, so it is not running full blast all winter.

Not ready for guards yet? We clean gutters and downspouts, flush them with water, reseal leaking joints and re-hang sagging sections with hidden hangers.
A tune-up also tells you how your gutters are holding up, so you know whether guards, repairs or replacement make the most sense for your house.

Undersized downspouts back up during heavy summer storms, and short ones dump water right next to the foundation. We upsize downspouts where needed and extend them away from the house.
Moving water several feet from the foundation is one of the cheapest ways to protect a Madison basement from seepage. On older homes we also check where the downspouts drain, since some still run into old clay tile lines that have collapsed over the years.

Years of overflowing gutters soak the fascia boards behind them until the wood rots and the gutters pull loose. We replace damaged fascia and soffit sections before new gutters or guards go back up.
Fixing the wood first means your guards are fastened to something solid and will stay straight for years. We match new trim to your siding and paint color as closely as we can so the repair does not stand out.

Some older guards, like plastic snap-in screens and foam inserts, eventually warp, sag or fill with debris. We remove failed guards and replace them with a sturdier micro-mesh system.
If you already have guards and still see overflow, we can tell you whether they can be adjusted or need to come off.

Pine needles, maple seeds and oak tassels slide through open screens and pack into gutters like felt. They are the main reason simple screens fail under Madison trees.
A fine micro-mesh with the right pitch keeps those small pieces on top, where they dry out and blow off instead of matting inside the gutter.

Tall homes and steep roofs are exactly where you do not want to be on a ladder. Our crews have the equipment and training to work safely at height.
For many Madison homeowners, getting off a two-story ladder for good is the main reason to install gutter guards in the first place.
Apartment buildings near campus, rental homes, office buildings along the Beltline, churches and small retail centers all deal with clogged gutters, overflow at entrances and winter ice. We schedule work around tenants and business hours.

Clogged gutters on rentals lead to water in basements, ice on walkways and maintenance calls. Guards cut down on cleaning visits and give owners one less seasonal task to schedule.

Overflowing gutters stain siding and freeze over sidewalks and doorways. We install guards and heavy-duty gutters sized for larger roof areas.

Large older roofs often have long runs, tall walls and big trees nearby. We plan access and phase the work so the building stays open.
Madison sits on a narrow isthmus between Lake Mendota and Lake Monona, and much of the city grew up under a canopy of old oaks, maples and elms planted along every block. That is beautiful in summer and hard on gutters the rest of the year.
Add summer thunderstorms that drop a lot of rain in a short time and long winters with heavy snow, and the same gutter problems turn up in house after house.

Most Madison gutters get hit twice: maple seeds and oak tassels in spring, then a heavy load of leaves in October and November. One cleaning a year rarely keeps up.
By the time the leaves are down, spring debris has already packed the bottom of the gutter, and the next storm overflows straight onto the foundation.

When gutters are full of wet leaves going into December, they freeze solid. Snowmelt from the roof has nowhere to go, so it refreezes at the eaves and builds into ice dams and heavy icicles.
That ice can pull gutters off the fascia and push water under the shingles into ceilings and walls. Clean, guarded gutters drain better through freeze-thaw cycles.

Summer thunderstorms in southern Wisconsin can dump an inch or more of rain in under an hour. Partly clogged gutters and small downspouts cannot keep up.
Water pours over the front edge, splashes against the siding and soaks the ground right next to the basement wall, which is how many wet basements start. Over time the splashing also wears out mulch beds, stains siding and erodes soil along the foundation, so the damage adds up quietly year after year.
Gutter guards work best as part of a complete drainage system. These related services keep the whole roof edge working, from the shingles to the ground.
Each one is priced separately so you only pay for what your house needs.
There is a lot of hard selling in the gutter guard business. We keep it simple: measure the house, show you what we found, recommend the guard that fits your trees and roof, and put the price in writing with no pressure.
Gutter guards are only as good as the gutters underneath them. This is the order we follow on every house.
We measure every gutter run, check pitch, hangers, seams, downspouts and fascia, and give you a written price.
Gutters are cleaned by hand and flushed with water, leaks are sealed and loose or sagging sections are re-hung.
Guards are fitted to each run, secured under the shingles or to the gutter lip, and trimmed neatly at corners and ends.
We run water through the system to check flow at every downspout, then clean up and haul away all debris.
The materials make the difference between a guard that lasts and one that sags after two winters. These are the parts that go on a typical Madison home.
Professionally installed micro-mesh gutter guards in Madison usually cost between $1,600 and $4,800 for a typical house. Price depends mostly on how many feet of gutter you have and how hard the roof is to reach.
What changes the price:
Total gutter length: guards are priced by the linear foot, so a ranch with 120 feet of gutter costs far less than a large two-story with 250 feet.
Roof height and pitch: two-story homes and steep roofs take more time and equipment to work on safely.
Condition of the gutters: sagging, leaking or badly pitched gutters need repair or replacement before guards go on.
Add-ons: new seamless gutters, larger downspouts, fascia repair or heat cable all add to the total.
Fall is the busiest time of year because that is when people notice their gutters. Installing before the leaves drop, or in early spring before the seed drop, saves you a full season of cleaning.
Many gutter guards pay for themselves over a few years compared with paying for two or three professional cleanings a year, and they remove the ladder risk entirely. They also help protect the fascia, siding, landscaping and foundation, which cost far more to repair than the guards themselves.
The free estimate shows exactly what your house needs before you spend anything. If you only need a cleaning and a few repairs this year, that is what we will quote.
Service | Typical Cost Range |
|---|---|
Gutter Cleaning (one visit) | $150 - $350 |
Micro-Mesh Guards, Small Ranch | $1,200 - $2,200 |
Micro-Mesh Guards, Two-Story Home | $2,500 - $4,800 |
Seamless Gutters (per linear foot) | $8 - $15 |
Seamless Gutters + Guards, Whole House | $4,000 - $8,500 |
Heat Cable for Ice Dams | $600 - $1,800 |
Madison, Middleton, Fitchburg, Verona, Monona, Sun Prairie, Waunakee, McFarland, Maple Bluff, Shorewood Hills and Cottage Grove.
The older neighborhoods on the Near East Side, Marquette, Tenney-Lapham, Vilas, Dudgeon-Monroe and Nakoma have the biggest trees and the oldest gutters. Many of these homes have narrow lots, tall rooflines and gutters that have been patched for decades, so we often pair guards with new seamless gutters and fascia repair.
On the west side, in Westmorland, Midvale Heights, Hill Farms and around Odana, post-war ranches and capes sit under mature oaks and maples that drop leaves and seeds all season. These homes are usually straightforward, one-story installs with a big payoff.
In Middleton, Verona, Fitchburg and Sun Prairie, newer subdivisions have fewer big trees but more two-story homes and steep roofs, where getting off the ladder and stopping ice dams are the main reasons homeowners call. Lakeside homes near Monona and Maple Bluff also see heavy wind-blown debris. Out in Waunakee, McFarland and Cottage Grove, open farm country brings strong winds that push snow and leaves into gutters even where there are few trees on the lot.
Clear answers to what Madison homeowners ask most about gutter guards, ice dams, seamless gutters and cost.
Most professionally installed micro-mesh gutter guards in Madison cost between $1,600 and $4,800, depending on how many feet of gutter you have, the height of the house and the condition of the gutters. You get an exact written price after the free estimate.
For most homes under mature oaks, maples or pines, yes. Guards keep leaves, seeds and needles out of the gutters, cut down on cleanings and keep you off the ladder. On a house with no trees nearby, regular cleaning may be enough, and we will tell you so.
For Madison trees, a stainless steel micro-mesh guard on an aluminum frame is usually the best choice. It blocks small debris like maple seeds, oak tassels and pine needles that slip through basic screens and foam inserts.
Guards help by keeping gutters from freezing solid with wet leaves, so meltwater can drain. They do not stop ice dams caused by attic heat loss on their own. For roofs that dam every winter, we add heat cable and may suggest attic ventilation or insulation improvements.
A rigid aluminum-framed guard fastened securely, combined with closely spaced hidden hangers, holds up well under snow load. Cheap plastic screens are the ones that crack and sag after a few winters.
Much less often. Some fine debris and pollen can collect on top of the mesh, especially on low-slope roofs, and an occasional rinse or brush-off keeps it flowing. You will not be scooping out packed leaves anymore.
Usually, yes, as long as the gutters are in decent shape. We clean, reseal and re-hang them first. If they are rusted, leaking badly or pitched wrong, new seamless gutters are the better choice.
Most Madison homes are done in a single day, including cleaning and minor repairs. Larger homes or jobs that include new gutters can take a second day.
Some guards slide under the first row of shingles, which some shingle makers discourage. We use mounting methods that fit your roof and can attach guards to the front of the gutter instead when needed. Ask us and we will check your roof type.
A properly installed micro-mesh guard takes in a lot of water, enough for the heavy summer storms we get in southern Wisconsin. If water overshoots in a downpour, it is usually a pitch or downspout issue we can fix.
Pine needles are one of the hardest debris types for gutters because they slide through open screens. Fine micro-mesh keeps them on top, where they dry out and blow away.
Only if they need it. Seamless aluminum gutters last a long time, and many just need cleaning and new hangers. If your gutters are sagging, rusted or leaking at many seams, replacing them first makes sense.
Late summer before the leaves fall, or early spring before the seed drop. That said, we install year-round when the weather allows, and getting guards on before winter helps reduce ice problems.
Yes. We work with landlords, property managers and business owners on rentals, apartment buildings and commercial properties across Madison.
We serve Middleton, Fitchburg, Verona, Monona, Sun Prairie, Waunakee, McFarland, Maple Bluff, Shorewood Hills, Cottage Grove and the surrounding parts of Dane County.
Get a Free Gutter Guard Estimate in Madison
Tell us about your house and what your gutters are doing. We will measure every run, check the gutters underneath and give you a written price before any work begins.
Estimates are typically available across Madison and nearby Dane County communities.